Training Requirements - Oce Arizona 440 GT User Manual

User Manual: Arizona (AZ) 440 GT, AZ 440 XT, AZ 460 GT, AZ 460 XT, AZ 480 GT, AZ 480 XT - Rev. B, 4/2013

Training Requirements

Training Requirements
Introduction
The operator must receive training for safety issues, printer operation, and
the appropriate ONYX Workflow software (ProductionHouse® or THRIVE)
prior to operating the printer.
Safety Training
Before operating the Océ Arizona 400 Series printer, make sure you have
read and understood all of Chapter 3 "Safety Guidelines".
Océ Operator Training
For optimal safety and print quality, all printer operators must have
received training by qualified Océ service personnel. Océ training provides
a general orientation to printer safety and operating procedures. This User
Manual is not a substitute for official training.
Onyx ProductionHouse Training
Maximum performance from the printer requires a properly trained
operator. Océ trains the operator in the use of the printer hardware and
software at installation. However, this is not a substitute for formal
training.
Operators must be fully versed in the operation of ONYX Workflow
software . For any operator unfamiliar with their operation, ONYX
ProductionHouse® or THRIVE training is required. Training courses are
available; contact your local representative for an ONYX-certified training
program.
76 Chapter 5 - How to Operate Your Océ Arizona Printer