How To Set Up A Print Job - Oce Arizona 400 Series GT User Manual

How to Set Up a Print Job

How to Set Up a Print Job
Introduction
This section explains how to select an image to print on your printer. The basic steps are
outlined here and explained below. More detailed explanations for some of these steps
are available in Chapter 4 "How to Navigate the User Interface".
• Prepare A Digital Image Using ONYX Workflow Software (ProductionHouse or
THRIVE)
• Print The Job From ONYX Workflow To The printer
• Perform Printhead Maintenance (If first print of the day)
• Select Job To Be Printed and Check Print Parameters
• Measure Media Thickness
• Select Print Icon, select Print Mode, and Confirm Media Thickness
• Prepare Media for Printing
Place And Register Media On The Printer Vacuum Table
Select Active Print Zones
Mask Active Vacuum Zones Not Covered With Media
Turn On Table Vacuum
Clean Media, if required
• Check the table to make sure that there are no obstacles that can interfere with the
travel of the gantry or carriage
Start the Print
Prepare a Digital Image with ProductionHouse or Postershop
Operator must be trained to use ProductionHouse or THRIVE. Training is provided by
ONYX.
Print The Job From Onyx ProductionHouse
When the job is sent from the ONYX software, the job transmission progress is indicated
in the lower right corner of the User Interface display. After the transmission has completed
it will appear in the list of Active print jobs in the Job Control Module.
Perform Printhead Maintenance (if this is the first print of the day)
Refer to the Maintenance section in this manual for details. This must be done at the
beginning of the work day or when image quality problems, such as banding, appears.
82 Chapter 5 - How to Operate Your Océ Arizona Printer