Maintenance; Printhead - Oce Arizona 400 Series GT User Manual

Note:
Maintenance Station Switches:
There are three switches inside of the maintenance station . They can be operated in
any order. For example, you can press the middle switch to raise the carriage to remove
debris from the underside of the carriage even when a purge isn't required.
Illustration
[154] Maintenance Station Switches
#
Left switch to activate
suction pump
How To Perform Maintenance
Verify that the ink temperature is at least 40° Centigrade (104° Fahrenheit) before you
1.
begin printhead maintenance.
Slide the drawer out from under the carriage to reveal the maintenance station.
2.
Press the Purge button to initiate a purge. The carriage will lower to its purge height
3.
(4mm above the table surface). Watch the ink as it falls from the heads. After a few seconds
most of the ink stops dripping and you can then raise the carriage.
Press the middle button to raise the carriage to its maximum height.
4.
Middle switch to raise
carriage
Chapter 12 - Printer Maintenance
Printhead Maintenance
Right switch to start an
ink purge
219