Oce Arizona 400 Series GT User Manual page 51

Flatbed Set- A dialog window automatically appears when confirmation is re-
tings quired. If it is closed before you select Confirm, it can be reopened
by clicking on this button.
Media Parameters
Enter or confirm the thickness of the media. The printer will auto-
matically adjust the carriage height to media thickness and also the
print gap. Media thickness confirmation is required only for the
first copy of a print job, unless it is changed during printing. If the
media thickness value is changed while printing, confirmation is
requested before printing the next copy.
Lamp Power Control
Allows the operator to control the power output of each UV lamp
independently. To extend lamp life, use the lowest setting that
provides adequate curing for a particular media.
Leading and Trailing Edge are relative to the direction of carriage
travel. To enable or disable this setting, see the User Interface sec-
tion of the Settings page "Tie lamp controls together". When en-
abled, this feature automatically matches the power of the trailing
UV lamp, when power of the leading UV lamp changes. It is still
possible to adjust the power of the trailing UV lamp individually,
when this setting is not enabled.
Roll enable Click on the Roll icon to enable or disable the Roll Media Option
print queue (this allows you check media parameters before the job
actually prints). Roll media print jobs will not print unless this icon
is selected.
Roll Media The Roll Media Manager allows the operator to load and unload
Manager media and to initialize the Roll module so that the tension on the
roll media is set and the job is ready to print.
Note:
Roll media print jobs do not require explicit user actions
to start the print job once Roll module is initialized (see
Roll Media Manager in the RMO) If this icon is selected,
and the job status is not on Hold, roll media print jobs will
start automatically when the printer receives the job.
Chapter 4 - How to Navigate the User Interface
Print Job Control Module
51