Led Behavior; Prerequisite - Dell Neworking S6000-ON Installation Manual

1 Serial Console
2 Master LED
3 Power LED
4 Fan Status LED
5 Locator LED
6 Stack ID
7 USB-A
8 USB-B Console
9 Management

LED behavior

The following S6000–ON system LED behavior is seen during ONIE operations:
Table 1. LED behavior
LED
System Status LED
Master LED
Fan LED
Power Status LED
Locator LED

Prerequisite

The following is a list of components required for a successful installation of the S6000-ON.
NOTE: Detailed installation instructions for the S6000-ON are provided in
• S6000–ON chassis
• AC cables to connect the AC power source to each of the chassis' AC power supplies (country/regional configured)
• Mounting brackets for rack installation (included)
• Screws for rack installation and #1 and #2 Phillips screwdrivers (not included)
• Ground cable (not included, optional)
• Ground cable screws (included)
Description
• Off—no power
• Blinking green—booting or system is in Diagnostic mode
• Solid green—normal operation
• Solid red—critical alarm
• Blinking red—noncritical alarm
• Solid green—system is in Stacking Master mode
• Off—system is in Slave mode
• Solid green—fan is powered on and running at the expected
RPM
• Solid yellow—fan failed including incompatible airflow direction
• Off—no power
• Solid green—normal operations
• Blinking yellow—a power supply has failed
• Off—locator function is disabled
• Blinking blue—locator function is enabled
Site Preparations and Install the S6000-ON.
The S6000–ON system 9