Led Display; Led Behavior - Dell EMC PowerSwitch Z9432F-ON Installation Manual

○ Fan tray handle 25 mm (0.99 in)

LED display

The Z9432F-ON switch includes LED displays on the I/O side of the switch. This section describes open networking installation
environment (ONIE) LED behaviors. Some LED behaviors may change after you install your software.

LED behavior

The following Z9432F-ON switch LED behavior is seen during ONIE operations:
1. SFP+ Port Activity LED
3. RJ45 Ethernet Port LED
5. Power LED
7. Locator LED
Table 1. Z9432F-ON switch LED behavior
LED
System Status/Health LED
Power LED
FAN LED
PSU LED
2. Port Activity LED
4. System LED
6. Fan LED
Description
● Off—No power
● Solid green—Normal operation
● Flashing green—Booting
● Solid yellow—Critical system error
● Flashing yellow—Noncritical system error, fan failure, or
power supply failure
● Off—No power
● Solid Green—Normal operation
● Solid yellow—POST is in process
● Flashing yellow—Power supply fault
● Off—No power
● Solid green—Normal operation; fan powered and running
at the expected RPM
● Flashing yellow—Fan fault—including incompatible airflow
direction when you insert the PSU or fan trays with
differing airflows
● Off—No power
● Solid green—Normal operation
● Flashing yellow—PSU warning event; power continues to
operate
● Flashing green—4Hz with five times on and off: Mismatch
● Flashing green—Firmware update
The Z9432F-ON switch 9