Set Garp Timer Join All; Set Garp Timer Leave; Set Garp Timer Leave All - Planet WGSW-24000 User Manual

▫
Mode Interface Config

8.6.23 set garp timer join all

This command sets the GVRP join time for all ports and per GARP. Join time is the interval between the
transmission of GARP Protocol Data Units (PDUs) registering (or re-registering) membership for a VLAN
or multicast group.
This command has an effect only when GVRP is enabled. The time is from 10 to 100 (centiseconds)
▫ 20 centiseconds (0.2 seconds)
Default
▫
Format set garp timer join all <10-100>
▫
Mode Global Config
8.6.23.1 no set garp timer join all
This command sets the GVRP join time for all ports and per GARP to 20 centiseconds (0.2 seconds).
This command has an effect only when GVRP is enabled.
▫
Format no set garp timer join all
▫
Mode Global Config

8.6.24 set garp timer leave

This command sets the GVRP leave time per port. Leave time is the time to wait after receiving an
unregister request for a VLAN or a multicast group before deleting the VLAN entry. This can be
considered a buffer time for another station to assert registration for the same attribute in order to
maintain uninterrupted service time is 20 to 600 (centiseconds).
This command has an effect only when GVRP is enabled.
Note
:
▫ 60 centiseconds (0.6 seconds)
Default
▫
Format set garp timer leave <20-600>
▫
Mode Interface Config
8.6.24.1 no set garp timer leave
This command sets the GVRP leave time per port to 60 centiseconds (0.6 seconds).
This command has an effect only when GVRP is enabled.
Note
:
▫
Format no set garp timer leave
▫
Mode Interface Config

8.6.25 set garp timer leave all

This command sets the GVRP leave time for all ports. Leave time is the time to wait after receiving an
unregister request for a VLAN or a multicast group before deleting the VLAN entry. This can be