Table of Contents
Advertisement
4.2.7 Port
4.2.7.1 Configuration
Use this page to configure the parameters of the distinct port.
Selection Criteria
Slot.Port - Selects the interface for which data is to be displayed or configured.
Configurable Data
STP Mode - The Select the Spanning Tree Protocol Administrative Mode for the port or LAG.
The possible values are:
Enable - select this to enable the Spanning Tree Protocol for this port.
Disable - select this to disable the Spanning Tree Protocol for this port.
Admin Mode - Use the pull-down menu to select the Port control administration state. You
must select enable if you want the port to participate in the network. The factory default is
enabled.
LACP Mode - Selects the Link Aggregation Control Protocol administration state. The mode
must be enabled in order for the port to participate in Link Aggregation. May be enabled or
disabled by selecting the corresponding line on the pull-down entry field. The factory default
is enabled.
Physical Mode - Use the pull-down menu to select the port's speed and duplex mode. If
you select auto the duplex mode and speed will be set by the auto-negotiation process.
Note that the port's maximum capability (full duplex and 100 Mbps) will be advertised.
Otherwise, your selection will determine the port's duplex mode and transmission rate. The
factory default is auto. The selection when applied against the "All" option in Slot.Port is
Figure 4-15 Message Log
Advertisement
Table of Contents
