Radius Accounting Mode; Radius Server Host - Planet WGSW-24000 User Manual

10.1.15 radius accounting mode

This command is used to enable the RADIUS accounting function.
▫
Default Disabled
▫
Format radius accounting mode
▫
Mode Global Config
10.1.15.1 no radius accounting mode
This command is used to set the RADIUS accounting function to the default value - i.e. the RADIUS
accounting function is disabled.
▫
Format no radius accounting mode
▫
Mode lobal Config

10.1.16 radius server host

This command is used to configure the RADIUS authentication and accounting server. If the 'auth' token
is used, the command configures the IP address to use to connect to a RADIUS authentication server.
Up to 3 servers can be configured per RADIUS client. If the maximum number of configured servers is
reached, the command will fail until one of the servers is removed by executing the no form of the
command. If the optional <port> parameter is used, the command will configure the UDP port number to
use to connect to the configured RADIUS server. In order to configure the UDP port number, the IP
address must match that of a previously configured RADIUS authentication server. The port number
must lie between 1 - 65535, with 1812 being the default value.
If the 'acct' token is used, the command configures the IP address to use for the RADIUS accounting
server. Only a single accounting server can be configured. If an accounting server is currently configured,
it must be removed from the configuration using the no form of the command before this command
succeeds. If the optional <port> parameter is used, the command will configure the UDP port to use to
connect to the RADIUS accounting server. The IP address specified must match that of a previously
configured accounting server. If a port is already configured for the accounting server then the new port
will replace the previously configured value. The port must be a value in the range 1 - 65535, with 1813
being the default value.
▫
Format radius server host {auth | acct} <ipaddr> [<port>]
▫
Mode lobal Config
10.1.16.1 no radius server host
This command is used to remove the configured RADIUS authentication server or the RADIUS
accounting server. If the 'auth' token is used, the previously configured RADIUS authentication server is
removed from the configuration. Similarly, if the 'acct' token is used, the previously configured RADIUS
accounting server is removed from the configuration. The <ipaddr> parameter must match the IP
address of the previously configured RADIUS authentication / accounting server.