Table of Contents
Advertisement
disabled, traffic is transmitted as untagged frames. The ID is a valid VLAN identification number.
▫
Format
no vlan tagging <1-4094>
▫
Mode
Interface Config
8.7 User Account Management Commands
These commands manage user accounts.
8.7.1 disconnect
This command closes a telnet session.
▫
Format
disconnect {<sessionID> | all}
▫
Mode
Privileged EXEC
8.7.2 show loginsession
This command displays current telnet and serial port connections to the switch.
▫
Format
show loginsession
▫
Mode
Privileged EXEC
▫
ID
Login Session ID
▫
User Name - The name the user will use to login using the serial port or Telnet. A new user may be
added to the switch by entering a name in a blank entry. The user name may be up to 8 characters,
and is not case sensitive. Two users are included as the factory default, 'admin' and 'guest'.
▫
Connection From - IP address of the telnet client machine or EIA-232 for the serial port
connection.
▫
Idle Time - Time this session has been idle.
▫
Session Time - Total time this session has been connected.
8.7.3 show users
This command displays the configured user names and their settings. This command is only available for
users with readwrite privileges. The SNMPv3 fields will only be displayed if SNMP is available on the
system.
▫
Format
show users
▫
Mode
Privileged EXEC
▫
User Name - The name the user will use to login using the serial port, Telnet or Web. A new user
may be added to the switch by entering a name in a blank entry. The user name may be up to eight
characters, and is not case sensitive. Two users are included as the factory default, 'admin' and
'guest'.
▫
Access Mode - Shows whether the operator is able to change parameters on the switch
(Read/Write) or is only able to view them (Read Only). As a factory default, the 'admin' user has
Read/Write access and the 'guest' has Read Only access. There can only be one Read/Write user
Advertisement
Table of Contents
