Table of Contents
Advertisement
factory default is enabled.
Java Mode - Enable or disable the java applet that displays a picture of the switch at the top
right of the screen. If you run the applet you will be able to click on the picture of the switch
to select configuration screens instead of using the navigation tree at the left side of the
screen. The factory default is disabled.
The following data are non-configurable:
Burned-in MAC Address - The burned-in MAC address used for in-band connectivity if you
choose not to configure a locally administered address.
Network Configuration Protocol Current - Indicates what network protocol was used on
the last, or current power-up cycle, if any.
4.2.4.4 Remote Session
This page includes the following fields:
Remote Login Timeout (minutes) - Specify how many minutes of inactivity should occur
on a telnet or SSH session before the switch logs off. A zero means there will be no timeout.
You may enter any number from 0 to 160. The factory default is 5.
Maximum Number of Remote Sessions - Use the pull-down menu to select how many
simultaneous telnet or SSH sessions will be allowed. The maximum is 5, which is also the
factory default.
Allow New Remote Sessions - If you set this to no, new telnet sessions will not be allowed.
The factory default is yes.
Figure 4-8 Network Connectivity Configuration
Advertisement
Table of Contents
