Table of Contents
Advertisement
4.3.6 Port Channel
4.3.6.1 LAG Configuration
Use this page to configure the link aggregation for gathering bandwidth.
Selection Criteria
Port Channel Name – You can use this screen to reconfigure an existing Port Channel, or
to create a new one. Use this pull-down menu to select one of the existing Port Channels, or
select 'Create' to add a new one. There can be a maximum of 6 Port Channels.
Configurable Data
Port Channel Name - Enter the name you want assigned to the Port Channel. You may
enter any string of up to 15 alphanumeric characters. A valid name has to be specified in
order to create the Port Channel.
Link Trap - Specify whether you want to have a trap sent when link status changes. The
factory default is enable, which will cause the trap to be sent.
Administrative Mode - Select enable or disable from the pull-down menu. When the Port
Channel is disabled no traffic will flow and LACPDUs will be dropped, but the links that form
the Port Channel will not be released. The factory default is enable.
STP Mode - The Spanning Tree Protocol Administrative Mode associated with the Port
Channel. The possible values are:
Disable - spanning tree is disabled for this Port Channel.
Enable - spanning tree is enabled for this Port Channel.
Participation - For each port specify whether it is to be included as a member of this Port
Channel or not. The default is exclude. There can be a maximum of 8 ports assigned to a
Figure 4-48 IGMP Snooping Interface Configuration
Advertisement
Table of Contents
