Planet WGSW-24000 User Manual page 89

Configurable Data
Port Priority - The priority for a particular port within the CST. The port priority is set in
multiples of 16. For example if the priority is attempted to be set to any value between 0 and
15, it will be set to 0. If it is tried to be set to any value between 16 and (2*16-1) it will be set
to 16 and so on.
Admin Edge Port - Specifies if the specified port is an Edge Port within the CIST. It takes a
value of TRUE or FALSE, where the default value is FALSE.
Port Path Cost - Set the Path Cost to a new value for the specified port in the common and
internal spanning tree. It takes a value in the range of 1 to 200000000.
Non-Configurable Data
Auto-calculate Port Path Cost - Displays whether the path cost is automatically calculated
(Enabled) or not (Disabled). Path cost will be calculated based on the link speed of the port
if the configured value for Port Path Cost is zero.
Port ID - The port identifier for the specified port within the CST. It is made up from the port
priority and the interface number of the port.
Port Up Time Since Counters Last Cleared - Time since the counters were last cleared,
displayed in Days, Hours, Minutes, and Seconds.
Port Mode - Spanning Tree Protocol Administrative Mode associated with the port or lag.
The possible values are Enable or Disable.
Port Forwarding State - The Forwarding State of this port.
Port Role - Each MST Bridge Port that is enabled is assigned a Port Role for each
spanning tree. The port role will be one of the following values: Root Port, Designated Port,
Alternate Port, Backup Port, Master Port or Disabled Port.
Designated Root - Root Bridge for the CST. It is made up using the bridge priority and the
base MAC address of the bridge.
Designated Cost - Path Cost offered to the LAN by the Designated Port.
Designated Bridge - Bridge Identifier of the bridge with the Designated Port. It is made up
using the bridge priority and the base MAC address of the bridge.
Designated Port - Port Identifier on the Designated Bridge that offers the lowest cost to the
LAN. It is made up from the port priority and the interface number of the port.
Topology Change Acknowledge - Identifies whether the next BPDU to be transmitted for
this port would have the topology change acknowledgement flag set. It is either "True" or
"False".
Hello time - Configured value of the parameter for the CST.
Edge port - indicates whether the port is enabled as an edge port. It takes the value
"Enabled" or "Disabled".
Point-to-point MAC - Derived value of the point-to-point status.
CST Regional Root - Bridge Identifier of the CST Regional Root. It is made up using the