Users Name; Users Passwd - Planet WGSW-24000 User Manual

and up to five Read Only users.
▫ SNMPv3 AccessMode - This field displays the SNMPv3 Access Mode. If the value is set to
Read-Write, the SNMPv3 user will be able to set and retrieve parameters on the system. If the
value is set to ReadOnly, the SNMPv3 user will only be able to retrieve parameter information. The
SNMPv3 access mode may be different than the CLI and Web access mode.
▫ SNMPv3 Authentication - This field displays the authentication protocol to be used for the
specified login user.
▫ SNMPv3 Encryption - This field displays the encryption protocol to be used for the specified login
user.

8.7.4 users name

This command adds a new user (account) if space permits. The account <username> can be up to eight
characters in length. The name may be comprised of alphanumeric characters as well as the dash ('-')
and underscore ('_'). The <username> is not case-sensitive.
Six user names can be defined.
▫
Format users name <username>
▫
Mode Global Config
8.7.4.1 no users name
This command removes an operator.
▫
Format no users name <username>
▫
Mode Global Config
The 'admin' user account cannot be deleted.
Note
:

8.7.5 users passwd

This command is used to change a password. The password should not be more than eight
alphanumeric characters in length. If a user is authorized for authentication or encryption is enabled, the
password must be at least eight alphanumeric characters in length. The username and password are not
case sensitive when a password is changed, a prompt will ask for the former password. If none, press
enter.
▫
Default No Password
▫
Format users passwd <username>
▫
Mode Global Config
8.7.5.1 no users passwd
This command sets the password of an existing operator to blank. When a password is changed, a
prompt will ask for the operator's former password. If none, press enter.