10.1.2 clear dot1x statistics
This command resets the 802.1x statistics for the specified port or for all ports.
▫
Format
clear dot1x statistics {<slot/port> | all}
▫
Mode
Privileged EXEC
10.1.3 clear radius statistics
This command is used to clear all RADIUS statistics.
▫
Format clear radius statistics
▫
Mode Privileged EXEC
10.1.4 dot1x defaultlogin
This command assigns the authentication login list to use for non-configured users for 802.1x port
security. This setting is over-ridden by the authentication login list assigned to a specific user if the user is
configured locally. If this value is not configured, users will be authenticated using local authentication
only.
▫
Format
dot1x defaultlogin <listname>
▫
Mode
Global Config
10.1.5 dot1x initialize
This command begins the initialization sequence on the specified port. This command is only valid if the
control mode for the specified port is 'auto'. If the control mode is not 'auto' an error will be returned.
▫
Format
dot1x initialize <slot/port>
▫
Mode
Privileged EXEC
10.1.6 dot1x login
This command assigns the specified authentication login list to the specified user for 802.1x port security.
The <user> parameter must be a configured user and the <listname> parameter must be a configured
authentication login list.
▫
Format
dot1x login <user> <listname>
▫
Mode
Global Config
10.1.7 dot1x max-req
This command sets the maximum number of times the authenticator state machine on this port will
transmit an EAPOL EAP Request/Identity frame before timing out the supplicant. The <count> value
must be in the range 1 - 10.
▫
Default
2
▫
Format
dot1x max-req <count>
▫
Mode
Interface Config