Table of Contents
Advertisement
and 255 separated by periods.
▫
Status - A pull down menu that indicates the receiver's status (enabled or disabled) and allows the
administrator/user to perform actions on this user entry:
Enable - send traps to the receiver
Disable - do not send traps to the receiver.
Delete - remove the table entry.
8.5.19 show trapflags
This command displays trap conditions. Configure which traps the switch should generate by enabling or
disabling the trap condition. If a trap condition is enabled and the condition is detected, the switch's
SNMP agent sends the trap to all enabled trap receivers. The switch does not have to be reset to
implement the changes. Cold and warm start traps are always generated and cannot be disabled.
▫
Format
show trapflags
▫
Mode
Privileged EXEC
▫
Authentication Flag - May be enabled or disabled. The factory default is enabled. Indicates
whether authentication failure traps will be sent.
▫
Link Up/Down Flag - May be enabled or disabled. The factory default is enabled. Indicates
whether link status traps will be sent. Multiple Users Flag.
▫
Multiple Users Flag - May be enabled or disabled. The factory default is enabled. Indicates
whether a trap will be sent when the same user ID is logged into the switch more than once at the
same time (either via telnet or serial port).
▫
Spanning Tree Flag - May be enabled or disabled. The factory default is enabled. Indicates
whether spanning tree traps will be sent.
▫
Broadcast Storm Flag - May be enabled or disabled. The factory default is enabled. Indicates
whether broadcast storm traps will be sent.
▫
DVMRP Traps - May be enabled or disabled. The factory default is disabled. Indicates whether
DVMRP traps will be sent.
▫
OSPF Traps - May be enabled or disabled. The factory default is disabled. Indicates whether
OSPF traps will be sent.
▫
PIM Traps - May be enabled or disabled. The factory default is disabled. Indicates whether PIM
traps will be sent.
8.5.20 snmp-server community
This command adds (and names) a new SNMP community. A community name is a name associated
with the switch and with a set of SNMP managers that manage it with a specified privileged level. The
length of name can be up to 16 case-sensitive characters.
Community names in the SNMP community table must be unique. If you make multiple
Note
:
Advertisement
Table of Contents
