Logout; Ping; Reload - Planet WGSW-24000 User Manual

copy system:running-config nvram:startup-config
copy <url> nvram:sslpem-root
copy <url> nvram:sslpem-server
copy <url> nvram:sslpem-dhweak
copy <url> nvram:sslpem-dhstrong
copy <url> nvram:sshkey-rsa1
copy <url> nvram:sshkey-rsa2
copy <url> nvram:sshkey-dsa
▫
Mode Privileged EXEC

8.8.9 logout

This command closes the current telnet connection or resets the current serial connection.
Save configuration changes before logging out.
Note
:
▫
Format logout
▫
Mode Privileged EXEC

8.8.10 ping

This command checks if another computer is on the network which is listening for connections. To use
this command, configure the switch for network (in-band) connection. The source and target devices
must have the ping utility enabled and running on top of TCP/IP. The switch can be pinged from any IP
workstation with which the switch is connected through the default VLAN (VLAN 1), as long as there is a
physical path between the switch and the workstation. The terminal interface sends three pings to the
target station.
▫
Format ping <ipaddr>
▫
Mode Privileged EXEC and User EXEC

8.8.11 reload

This command resets the switch without powering it off. Reset means that all network connections are
terminated and the boot code executes. The switch uses the stored configuration to initialize the switch.
You are prompted to confirm that the reset should proceed. A successful reset is indicated by the LEDs
on the switch.
▫
Format reload
▫
Mode Privileged EXEC