Table of Contents
Advertisement
configured, the max retransmit value on each will be exhausted before the next server is
attempted. A retransmit will not occur until the configured timeout value on that server has
passed without a response from the RADIUS server. Therefore, the maximum delay in
receiving a response from the RADIUS application equals the sum of (retransmit times
timeout) for all configured servers. If the RADIUS request was generated by a user login
attempt, all user interfaces will be blocked until the RADIUS application returns a response.
Accounting Mode - Selects if the RADIUS accounting mode is enabled or disabled.
Non-Configurable Data
Current Server IP Address - The IP address of the current server. This field is blank if no
servers are configured.
Number of Configured Servers - The number of RADIUS servers that have been
configured. This value will be in the range of 0 and 3.
4.4.2.2 RADIUS Server Configuration
This page is to configure the RADIUS server connection features.
RADIUS Server IP Address - Selects the RADIUS server to be configured. Select add to
add a server.
IP Address - The IP address of the server being added.
Port - The UDP port used by this server. The valid range is 0 - 65535.
Secret - The shared secret for this server. This is an input field only.
Apply - The Secret will only be applied if this box is checked. If the box is not checked,
anything entered in the Secret field will have no affect and will not be retained. This field is
only displayed if the user has READWRITE access.
Primary Server - Sets the selected server to thePrimary or Secondary server.
Figure 4-69 RADIUS Configuration
Advertisement
Table of Contents
