Planet WGSW-24000 User Manual page 133

Privileged EXEC)
Quick Start up IP Address
To view the network parameters the operator can access the device by the following three methods.
▫ Simple Network Management Protocol - SNMP
▫ Telnet
▫ Web Browser
Helpful Hint: The user should do a "copy system:running-config nvram:startup-config"
Note
:
after configuring the network parameters so that the configurations are not lost
Command
show network
(in User EXEC)
network parms
(in Privileged EXEC)
Table 5-3 Quick Start up Account Management
Displays the Network Configurations
IP Address - IP Address of the interface
Default IP is 0.0.0.0
Subnet Mask - IP Subnet Mask for the interface
Default is 0.0.0.0
Default Gateway - The default Gateway for this interface
Default value is 0.0.0.0
Burned in MAC Address - The Burned in MAC Address used for
in-band connectivity
Locally Administered MAC Address - Can be configured to allow a locally
administered MAC address
MAC Address Type - Specifies which MAC address should be used for
in-band connectivity
Network Configurations Protocol Current - Indicates which network
protocol is being used
Default is none
Management VLAN Id - Specifies VLAN id
Web Mode - Indicates whether HTTP/Web is enabled.
Java Mode - Indicates whether java mode is enabled.
network parms <ipaddr> <netmask> [<gateway>]
Details