The WGSW-24000 can be configured through an Ethernet connection, make sure the manager PC must
be set on same the IP subnet address with the switch. For example, if you have changed the default IP
address of the Switch to 192.168.16.234 with subnet mask 255.255.255.0 via console, then the manager
PC should be set at 192.168.16.x (where x is a number between 2 and 254) with subnet mask
255.255.255.0. Or you can use the factory default IP address 192.168.0.100 to do the relative
configuration on manager PC.
Use Internet Explorer 5.0 or above Web browser. Enter IP address http://192.168.0.100 (the
factory-default IP address or that you have changed via console) to access the Web interface.
When the following login screen appears, please enter the default username "admin" and no password
(or the username/password you have changed via console) to login the main screen of Switch. The login
screen in Figure 4-1 appears.
4.1 Main Menu
After a successful login, the main screen appears, the main screen displays the port status and a list of
System section and the topics it provide. As showed in Figure 4-2.
System Name - Enter the name you want to use to identify this switch. You may use up to
31 alpha-numeric characters. The factory default is blank.
System Location - Enter the location of this switch. You may use up to 31 alpha-numeric
characters. The factory default is blank.
System Contact - Enter the contact person for this switch. You may use up to 31
alpha-numeric characters. The factory default is blank.
4. Web Configuration
Figure 4-1 Login screen