Show Ip Ssh; Http Commands; Ip Http Secure-Port; Ip Http Secure-Protocol - Planet WGSW-24000 User Manual

10.2.3 show ip ssh

This command displays the ssh settings.
▫
Format show ip ssh
▫
Mode Privileged EXEC
▫ Administrative Mode - This field indicates whether the administrative mode of SSH is enabled or
disabled.
▫ Protocol Level - The protocol level may have the values of version 1, version 2 or both versions 1
and version 2.
▫ Connections - This field specifies the current ssh connections.

10.3 HTTP Commands

The commands in this section is not supported currently

10.3.1 ip http secure-port

This command is used to set the sslt port where port can be 1-65535 and the default is port 443.
▫
Default 443
▫
Format ip http secure-port <portid>
▫
Mode Privileged EXEC
10.3.1.1 no ip http secure-port
This command is used to reset the sslt port to the default value.
▫
Format no ip http secure-port
▫
Mode Privileged EXEC

10.3.2 ip http secure-protocol

This command is used to set protocol levels (versions). The protocol level can be set to TLS1, SSL3 or to
both TLS1 and SSL3.
▫
Default SSL3 and TLS1
▫
Format ip http secure-protocol [SSL3] [TLS1]
▫
Mode Privileged EXEC
10.3.2.1 no ip http secure-protocol
This command is used to remove protocol levels (versions) for secure HTTP.
▫
Format no ip http secure-protocol [SSL3] [TLS1]
▫
Mode Privileged EXEC

10.3.3 ip http secure-server

This command is used to enable the secure socket layer for secure HTTP.