Planet WGSW-24000 User Manual page 134

Quick Start up Uploading from Switch to Out-of-Band PC (Only XMODEM)
Command
copy {
nvram:startup-config |
nvram:errorlog |
nvram:msglog |
nvram:traplog} <url>
Table 5-4 Quick Start up Uploading from Switch to Out-of-Band PC (XMODEM)
Quick Start up Downloading from Out-of-Band PC to Switch (Only XMODEM)
Command
copy <url>
{nvram:startup-config |
system: image}
Table 5-5 Quick Start up Downloading from Out-of-Band PC to Switch (Only XMODEM)
Quick Start up Downloading from TFTP Server
Before starting a TFTP server download, the operator must complete the Quick Start up for the IP
Address.
Command
copy <url>
IP Address range from 0.0.0.0 to 255.255.255.255
Subnet Mask range from 0.0.0.0 to 255.255.255.255
Gateway Address range from 0.0.0.0 to 255.255.255.255
Table 5-4 Quick Start up IP Address
The types are:
▫ config - configuration file
▫ errorlog - error log
▫ system trace - system trace
▫ traplog - trap log
The URL must be specified as:
▫ xmodem:filepath/fileName
This starts the upload and also displays the mode of uploading and the
type of upload it is and confirms the upload is taking place.
For example:
If the user is using HyperTerminal, the user must specify where the file is
going to be received by the PC.
Sets the destination (download) data type to be an image (system:image)
or a configuration file (nvram:startup-config).
The URL must be specified as:
xmodem:filepath/fileName
For example:
If the user is using HyperTerminal, the user must specify which file is to be
sent to the switch.
The Switch will restart automatically once the code has been downloaded.
Sets the destination (download) data type to be an image (system:image)
Details
Details
Details