Match Destination-Address Mac; Match Dstip; Match Dstl4Port - Planet WGSW-24000 User Manual

9.4.4.1 no match class-map
This command removes from the specified class definition the set of match conditions defined for another
class. The <refclassname> is the name of an existing DiffServ class whose match conditions are being
referenced by the specified class definition. Note: there is no [not] option for this match command.
▫
Default None
▫
Format no match class-map <refclassname>
▫
Mode Class-Map Config

9.4.5 match destination-address mac

This command adds to the specified class definition a match condition based on the destination MAC
address of a packet. The <macaddr> parameter is any layer 2 MAC address formatted as six, two-digit
hexadecimal numbers separated by colons (e.g., 00:11:22:dd:ee:ff). The <macmask> parameter is a
layer 2 MAC address bit mask, which need not be contiguous, and is formatted as six, two-digit
hexadecimal numbers separated by colons (e.g., ff:07:23:ff:fe:dc). The optional [not] parameter has the
effect of negating this match condition for the class (i.e., match all destination MAC addresses except for
what is specified here).
▫
Default None
▫
Format match [not] destination-address mac <macaddr> <macmask>
▫
Mode Class-Map Config

9.4.6 match dstip

This command adds to the specified class definition a match condition based on the destination IP
address of a packet. The <ipaddr> parameter specifies an IP address. The <ipmask> parameter specifies
an IP address bit mask; note that although similar to a standard subnet mask, this bit mask need not be
contiguous. The optional [not] parameter has the effect of negating this match condition for the class (i.e.,
match all destination IP addresses except for what is specified here).
▫
Default None
▫
Format match [not] dstip <ipaddr> <ipmask>
▫
Mode Class-Map Config

9.4.7 match dstl4port

This command adds to the specified class definition a match condition based on the destination layer 4
port of a packet using a single keyword or numeric notation or a numeric range notation.
To specify the match condition as a single keyword, the value for <portkey> is one of the supported port
name keywords. The currently supported <portkey> values are: domain, echo, ftp, ftpdata, http, smtp,
snmp, telnet, tftp, www. Each of these translates into its equivalent port number, which is used as both
the start and end of a port range.