Hi-Z Sync Input/Output Boards; Hi-Z Sync Input/Output Boards Specifications - AMX Optima SD Instruction Manual

Hi-Z Sync Input/Output Boards

Applicability Notice
This chapter pertains to Hi-Z sync input/output boards (with BNC connectors) contained in the
Optima SD systems in the following table:
Signal(s)
RGBHV
RGBHV+Stereo
RGBHV
RGBHV+Stereo
RGBHV
RGBHV+Stereo
RGBHV
RGBHV+Stereo
Optima SD systems use Hi-Z sync boards to route horizontal and vertical sync signals in conjunction
with the 500 MHz video boards (see page 35). If the system supports audio, the stereo audio board
(see page 39) is located below the Hi-Z sync boards.
Signals may only be routed from the inputs on a board to the outputs on the same board because each
board has its own switching matrix.
FIG. 21
Hi-Z sync input/output boards (with stereo audio board)

Hi-Z Sync Input/Output Boards Specifications

Applies to Hi-Z sync boards contained in the Optima SD systems listed above.
Specifications
Input Level (max.)
Input Impedance
Output Level (max.)
Output Impedance
In/Out Polarity
Output Signal Level
Connector Type
AMX reserves the right to modify its products and their specifications without notice.
Optima SD Instruction Manual
Configuration
16x16
16x16
8x16
8x16
12x12
12x12
16x8
16x8
Parameter Conditions
Active high or low
Hi-Z Sync Input/Output Boards
System Sales #
FGP46-1616-560
FGP46-1616-567
FGP46-0816-560
FGP46-0816-567
FGP46-1212-560
FGP46-1212-567
FGP46-1608-560
FGP46-1608-567
Value
+5.5 V
22 kohms
+5.5 V
75 ohms
Output polarity follows input polarity
Unity gain
BNC
37