Network Management Session - Allied Telesis AT-IS230-10GP Installation Manual

Chapter 5: Power On Switch
Network
Management
Session
88
Note
The baud rate must be set to the default 9600 bps to configure the
boot loader.
4. Press Enter. You are prompted for the name and password of the
manager account.
5. Enter the username and password. The default values are manager
and friend, respectively.
Note
The username and password are case sensitive.
The switch starts the local management session and displays the
following prompt:
awplus>
This prompt represents the User Exec mode in the command line
interface in the switch. Refer to the AT-IS230-10GP switch Reference
Guide for the available CLI commands.
This section contains the procedure for starting the AT-IS230-10GP
management session via a network connection. Please review the
following information before performing the procedure:
A network management session may be established via any of the

Ethernet ports of the switch.
A network management session shares the Ethernet connection

with active network traffic.
The switch needs an IP address for a network management

session. The factory default IP address is 192.168.1.1.
The Web and Command Line Interface (CLI) management

interfaces are available over a network connection.
The Simple Network Management Protocol (SNMP) is available on

both the Web and CLI management interfaces.
To start a network management session, perform the following procedure:
1. Connect one of the Ethernet ports on the switch to an existing network.
2. Connect your computer console to the same local area network (LAN)
that is connected to the AT-IS230-10GP switch switch.
3. If you choose to use the Web management interface, perform the
following steps:
a. Launch your web browser on the PC.
b. In the browser's URL address bar, type the switch's default IP
address (192.168.1.1).