Kyocera QCP 6035 Reference Manual page 85

5. Position the infrared port of your phone within a few inches of the infrared port
of your computer.
6. Tap the HotSync icon to start the synchronization.
After you have set the computer to synchronize data using the infrared port, you
must change the computer settings if you want to return to using the cradle for
synchronization.
1. If necessary, connect the cradle to a serial (COM) port of your computer and
plug the power cord into an outlet.
2. Click in the Windows system tray to open the menu.
3. From the menu, choose Setup. Then click Local.
4. Select the COM port to which your cradle is connected.
5. Click OK.
You will also have to reset your Kyocera smartphone for synchronizing by using the
cradle. To do this, place your Kyocera smartphone in the cradle and follow these
procedures:
1. Tap to view the Applications Launcher.
2. Tap to select HotSync.
3. If Local is not already selected, tap Local.
4. Tap the below the icon and select Direct Serial.
You can leave the computer set to synchronize data using the infrared port and still
use the cradle. This is useful if you synchronize data from the phone to both your
desktop computer and a laptop. When you travel, you don't have to carry a cradle
or cable because your phone is set to synchronize data via the infrared port. When
you're in the office, just return the phone to the cradle.