Kyocera QCP 6035 Reference Manual page 207

When it is turned on, your phone reads the date and time over the air and
automatically sets them. If you prefer, however, you can turn this automatic feature
off and set the time manually.
1. If you want your phone to set the date, time, and time zone automatically, tap
Automatic.
2. If you want to adjust the date, time, and time zone yourself, tap Manual and do
the following:
a. Tap the Time box. Select the correct time, including AM or PM.
b. Tap the Date box. Select the correct date.
c. Tap the below Time Zone. Select the correct time zone.
d. If your region is currently using Daylight Savings Time, put a check mark
beside Daylight Savings is in effect.
3. If you want the time zone to appear on screen when the time is displayed, put a
check mark beside Show Time-Zone with Time. If you don't want the time zone
to appear, tap the check box again to remove the check mark.
When the Beam Receive feature is turned on, your phone can receive information
that has been "beamed" from other devices with infrared ports, including other
Kyocera smartphones, Palm devices, and laptops.
1. Open the General Preferences screen.
2. Tap On in the Beam Receive line.
3. To turn the beaming feature off, tap Off in the Beam Receive line.
4. Tap Done.
1. To adjust the contrast of the screen, open the General Preferences screen.
2. Tap Contrast.
3. Drag the slider bar left to make the screen lighter or right to make it darker.
4. When you have finished, tap Done.