Kyocera QCP 6035 Reference Manual page 84

7. In the same folder where you unzipped W95 or W98ir.exe, find the file
Setup.exe. Double-click it to begin installation.
8. Accept the defaults provided by the Add Infrared Device Wizard, except when
the Wizard asks you to select the port to which your infrared device is
connected. Be sure that an available communications port is selected. Do not
select the port that the HotSync Manager currently uses.
9. If an alert appears telling you that there is a communication port conflict, click
OK and proceed with the rest of the installation using the defaults provided.
When your computer is prepared for infrared synchronization, you must specify the
simulated port to be used.
1. Click in the Windows system tray to open the menu.
2. Make sure that Local is checked on the menu. Then click Setup.
3. Click the Local tab.
4. In the Serial Port drop-down box, select the COM port that was given as the
simulated port in the Options tab of the Infrared Monitor (in this example,
COM4).
5. Click OK.
The HotSync Manager is now communicating with the simulated port defined
for infrared communication. This means you cannot use your cradle again until
you reconfigure the HotSync Manager to communicate with the port defined for
cradle synchronization.
1. Tap to view the Applications Launcher.
2. Tap to select HotSync.
3. If Local is not already selected, tap Local.
4. Tap the below the icon and select IR to a PC/Handheld.