Kyocera QCP 6035 Reference Manual page 56

1. Tap the screen where you want your text to go.
2. Use the table on page 55
For example, the stroke below creates the letter "n."
Start the stroke at
the heavy dot.
You use the same shapes to create both upper- and lowercase letters.
3. Position the stylus on the left side of the Graffiti writing area.
4. Start at the heavy dot. Draw the shape as it appears in the table.
Don't try to draw the dot itself. The dot is there to show the starting point.
5. Lift the stylus from the screen at the end of the stroke shape.
When you lift the stylus from the screen, the letter appears at the insertion point.
You can immediately begin the stroke for the next character.
NOTE:
Graffiti tips
When writing with Graffiti, keep these tips in mind:
Accuracy improves when you write large characters. Draw strokes that nearly
fill the Graffiti writing area.
To delete characters, place the insertion point to the right of the character you
want to delete and make the backspace stroke (a line from right to left) in the
Graffiti writing area.
Write at natural speed. Writing too slowly can cause recognition errors.
Do not write on a slant. Vertical strokes should be parallel to the sides of the
Graffiti writing area.
For some letters, there are two different stroke shapes. Use the one that's easiest
for you.
If you forget a stroke, a full-screen pen stroke from bottom to top will open
Graffiti Help. Place the stylus in the Graffiti writing area and drag it to the top
of the screen.
to find the stroke shape for the letter you want to write.
Lift the stylus here.