Kyocera QCP 6035 Reference Manual page 13

Both of the batteries—the main battery you just installed and the internal backup
battery—are recharged when the phone is connected to power. You can charge the
batteries using either the power cable or the sync cradle.
To charge the batteries using the power cable
1. Insert the small round plug of the
power cable into the round port on the
base of the phone. Plug the other end
into an AC power outlet.
The message "Phone is charging"
appears on the screen. Before your first
use of the phone, wait until the
message "Charging is complete"
appears. If the battery is completely
drained, it may take 6–8 hours to charge the first time.
2. Unplug the phone from the power cable.
To charge the batteries in the sync cradle
1. Place the sync cradle on a flat surface near your computer.
2. Insert the small round plug of the power cable (a) into the base of the sync cradle.
Plug the other end of the cable into a power outlet.
Sync cradle
3. To attach the sync cradle to your computer, do the following:
a. Turn off the computer.
b. Plug the data cable from the sync cradle (b) into a serial communications
(COM) port on your computer. The sync cradle requires a dedicated port; it
cannot share a port with an internal modem, IR port, or other device.
c. Turn on the computer.
4. Slide the base of the phone into the sync cradle.
Data cable attaches to computer COM port.
Power cable attaches to AC power outlet.