Kyocera QCP 6035 Reference Manual page 14

The message "Phone is charging" appears on the
screen. Before your first use of the phone, wait
until the message "Charging is complete"
appears. If the battery is completely drained, it
may take 6–8 hours to charge the first time.
Once the main battery is charged, you can use the
Kyocera Smartphone in the cradle or out of the
cradle for all functions. Leaving the phone in the
cradle when you are not using it is a convenient
way to keep the battery charged.
5. If you have purchased an extra battery, you can
recharge it in the cradle at the same time. Slide the battery into the rear port with
the Kyocera label facing up.
The light on the sync cradle shows the status of the battery in the rear port.
Red—The battery is not charged.
Green—The battery is fully charged.
Flashing red—The battery is not making contact or there is a charging
problem. Reset the battery. If the problem is not resolved, contact your
service provider.
NOTE:
1. With the flip closed, press and hold
message "Powering on" on the screen.
2. Remove the stylus from its slot on the top left side of the phone.
3. Open the flip. Follow the procedures in the welcome screens to calibrate the
phone. Use the stylus to tap the screen when you are instructed to do so. To
prevent scratches, never use a pen, pencil, or other sharp object to tap or write
on the screen. The phone is now ready to use.
for a few seconds. You see the