Kyocera QCP 6035 Reference Manual page 191

2. Tap to open Data/Fax mode.
NOTE:
3. Tap to open the Data/Fax mode menu.
4. From the Options menu, tap Settings.
This screen shows the serial communications settings between your computer
and the phone. The default settings are adequate in most situations, but you can
change these settings if necessary. Refer to your computer user guide if you need
to see what the settings are for your computer.
5. Tap Speed and select 19200.
NOTE:
6. If you need to change the bit settings to match your computer requirements, tap
Flags and select one of the following:
8 data bits; no parity; 1 stop bit
7 data bits; 1 bit parity; 1 stop bit
7 data bits; no parity; 2 stop bits
NOTE:
7. Do not change the Flow Control setting. Leave Flow Control set to Hardware.
You see status information beginning with "Initializing
Modem" and continuing to "Ready to Send Data or Faxes."