Kyocera QCP 6035 Reference Manual page 247

Before you can make a call using voice commands, you must "train" the phone to
recognize your voice and you must place the names to be called in your Voice Book.
See "Training Voice Dial" on page
1. To activate voice dialing, do one of the following:
If the phone is in the cradle, in the hands-free car kit, or attached to external
power, say "Wake-up" and wait for the beep. After the beep, say "Wake-up"
again. If you prefer to use a different command than "Wake-up," you can
train the phone to respond to another word.
If the phone is not in the cradle, in the hands-free car kit, or attached to
external power, press
The message "Speak a name or press
voice prompt says "Speak a name."
2. Speak the name of the person you want to call.
If the phone recognizes the name from your Voice Book, the voice prompt
says "Calling [name]" and places the call.
If the phone does not recognize the name, the voice prompt says "Did you
say ______?" and fills in the closest name match in your Voice Book. Answer
"Yes" or "No" until the voice prompt speaks the correct name and places the
call.
1. If you want to answer incoming phone calls by voice, set up the phone as
follows:
Place the phone in the cradle, in the hands-free car kit, or attach it to external
power.
Make sure the phone is not set to vibrate instead of ringing. (See
Sounds preferences" on page
Turn Auto-answer off. (See
When you receive an incoming call, the voice prompt says "Incoming call.
Answer?" or "Incoming roam call. Answer?" This message is given twice. If you
do not respond, the phone rings.
2. To accept the call, answer "Yes" or press any key except
244.
.
to redial" appears on the screen. The
215.)
"Setting Phone preferences" on page
"Setting
206.)
.