Kyocera QCP 6035 Reference Manual page 12

The batteries in your phone are delivered partially charged. Before first use, you
must install the main battery and fully charge it. You must also allow enough time
for the internal backup battery to charge completely. You will need the following:
Kyocera smartphone
battery
phone power cable
sync cradle (optional)
1. Hold the phone so the keypad faces away from
you.
2. Open the battery compartment door on the
lower back of the phone using your finger or the
stylus.
3. Lift off the battery compartment door.
IMPORTANT:
4. Slide the battery into the battery compartment
with the Kyocera label facing you.
The end of the battery with four copper-colored
depressions goes toward the top of the phone.
5. Apply gentle pressure until the battery snaps
into place.
6. Replace the battery cover.
NOTE
Do NOT
remove
this plug.
Open here.