Kyocera QCP 6035 Reference Manual page 188

Transmits the User ID information entered in the User ID line of the
Network Preferences screen.
Transmits the Password (from the Password line of the Network
Preferences screen). If you did not enter a password there, this
command prompts you to enter one. The Password command is
usually followed by a Send CR command.
Tells the phone to wait a specific number of seconds before
executing the next command in the login script.
Reads an IP address and uses it as the IP address for the phone. This
command is used with SLIP connections.
Opens a dialog and prompts you to enter text (for example, a
password or a security code).
Identifies the last line in the login script.
8. Repeat steps 6–7 until the login script is complete.
9. Tap OK.
You can use the following non-ASCII characters in a login script. This information
is provided for advanced users who understand the use and requirements of such
characters in a custom login script.
^ char
You may use the caret ( ^ ) to transmit ASCII command characters. If you send ^char,
and the ASCII value of char is between @ and _, then the character is automatically
translated to a single-byte value between 0 and 31. For example, ^M is converted to
a carriage return. If char is a value between a and z, then the character sequence is
translated to a single-byte value between 1 and 26. If char is any other value, then
the character sequence is not subject to any special processing.
For example, the string "Joe^M" transmits Joe, followed by a carriage return.
Carriage return and line feed
You may include carriage return and line feed commands as part of the login script,
when entered in the following format:
<cr>Sends or receives a carriage return
<lf>Sends or receives a line feed
For example, the string "waitfor Joe<cr><lf>" waits to receive Joe followed by a
carriage return and line feed from the remote computer before executing the next
command in the script.