Waveform Playback - Rigol DS6000 Series User Manual

10 Waveform Recording

Waveform Playback

Waveform playback can play back the waveforms currently recorded. Press UTIL 
Record  Mode and use
shown in the figure below is displayed at the upper-right corner of the screen,
indicating the specific frame currently displayed on the screen. During the playback,
this value would change continuously.
Please refer to the following descriptions to set the playback parameters.
1. Play Mode
Press this softkey to set the playback mode to cycle or single.
: cycle playback. Play from the start frame to the end frame and then

repeat until you stop it manually.
: single playback. Play from the start frame to the end frame and

then stop.
2. Interval
Press this softkey; use
adjust the time interval of the playback with a small step value or rotate the
outer knob of the navigation knob
playback within a relatively larger range. (The greater the rotation amplitude of
the outer knob, the faster the variations in the values.) The range availbale is
from 100 ns to 10 s and the default is 100 ns.
3. Start Frame
Press this softkey and use
is 1 and the maximum is the maximum number of frames recorded.
4. Current Frame
Press this softkey; use
adjust the current frame at the specified step (1) or rotate the outer knob of the
navigation knob
range. (The greater the rotation amplitude of the outer knob, the faster the
variations in the values.) By default, the current frame is the same with the end
frame. The setting range of the current frame is related to the start frame and
DS6000 User's Guide
to select "Play back". At this point, the information as
or the inner knob of the navigation knob
to set the start frame of the playbak. The default
or the inner knob of the navigation knob
to quickly adjust the current frame within a relatively larger
to quickly adjust the time interval of the
RIGOL
to
to
10-5