Flow Control Operation Of The Gemac; Transmitting A Pause Control Frame; Figure 6-3: Pause Request Timing - Xilinx LogiCORE IP MAC v8.5 User Manual

R

Flow Control Operation of the GEMAC

Transmitting a PAUSE Control Frame

Core-initiated Pause Request
If the GEMAC core is configured to support transmit flow control, the client can initiate a
pause control frame by asserting pause_req (see
81).
This action causes the core to construct and transmit a pause control frame on the link with
the following MAC Control frame parameters
•
•
•
If the transmitter is inactive at the time of the pause request, this pause control frame is
transmitted immediately. If the transmitter is currently busy, the current frame being
transmitted is allowed to complete, followed by the pause control frame (in preference to
any pending client-supplied frame).
A pause control frame initiated by this method is transmitted even if the transmitter has
ceased in response to receiving an inbound pause request.
Note:
asserted numerous times in a short time period (before the control pause frame transmission has
begun), only a single pause control frame is transmitted. The most recent value sampled will be the
pause_val[15:0] value used.
Client Initiated Pause Request
For maximum flexibility, flow control logic can be disabled in the core and alternatively
implemented in the client logic connected to the core (see
on page
client interface using the same transmission procedure as a standard Ethernet frame (see
"Transmitting Outbound Frames," on page
56
-- DISCONTINUED PRODUCT --
Figure 6-3 illustrates pause request timing.
gtx_clk
pause_req
pause_val[15:0]

Figure 6-3: Pause Request Timing

The destination address used is an IEEE802.3 globally assigned multicast address (to
which any flow control-capable MAC will respond).
The source address used is the configurable pause frame MAC address
Configuration," on page 79).
The value sampled from the pause_val[15:0] port at the time of the pause_req
assertion will be encoded into the MAC control parameter field to select the duration
of the pause (in units of pause_quantum).
Only a single pause control frame request is stored by the transmitter. if pause_req is
81). Any type of control frame can be transmitted through the core through the
www.xilinx.com
Chapter 6: Using Flow Control
"Flow Control Configuration," on page
(Figure 6-2):
"Flow Control Configuration,"
47).
1-Gigabit Ethernet MAC v8.5 User Guide
(see"Receiver
UG144 April 24, 2009