Collate/Offset Copying - Kyocera TASKalfa 420i Operation Manual

Ready to copy.
Duplex
Original
1-sided
>>1-sided
1-sided
Place original.
>>2-sided Binding
Left/Right
2-sided
>>1-sided
2-sided
>>2-sided
Original : ---
Book
:
Zoom 100%
>>1-sided
Paper : ---
Book
Preview
>>2-sided
Add Shortcut
Status

Collate/Offset Copying

The machine can collate and offset at the same time as it copies.
You can use the Collate/Offset copy function for tasks such as those shown below.
Collate
3
2
1
Original
Offset
Without Document Finisher
3
2
1
Original
OPERATION GUIDE
Copies
Binding
Top
Top Edge Top
Original
Orientation
Cancel OK
08/08/2009 10:10
3
2
1
3
2
1
3
2
1
Copy
3
2
1
3
2
1
Copy (each set)
6
If you choose [2-sided>>1-sided],
[2-sided>>2-sided], [Book>>1-sided] or
[Book>>2-sided], select the binding edge of the
originals of Original.
7
Press [Original Orientation] to select orientation of
the originals, either [Top Edge Top] or [Top Edge
Left]. Then press [OK].
8
Press [OK].
9
Press the Start key.
Once an original placed on the platen is scanned,
replace it with the next one. Then, press the Start
key.
After scanning all originals, press [Finish Scan] to
start copying.
Scan multiple originals and deliver complete sets of
copies as required according to page number.
If the optional document finisher is not installed, when
you use offsetting, printed copies are produced after
rotating each set (or page) by 90º.
NOTE:
You need to load the same sized paper with
different orientation in the paper source other than the
selected paper source. The paper sizes supported in
Offset are A4, B5, Letter and 16K.
Basic Operation
3
3-13