Output Destination - Kyocera TASKalfa 420i Operation Manual

Copying Functions

Output Destination

You can use the procedure below to select an output destination such as the optional document finisher for your
copies.
NOTE:
Optional output destinations include the job separator, built-in finisher, document finisher, 3,000 sheet
document finisher, and mailbox.
The table below shows the available output destinations.
Destination
Top tray
Finisher Tray*
Tray A, Tray B*, Tray C*
Job Separator Tray
Tray 1 to 7*
* Copy output orientation can be selected either as face-up (print facing up) or face-
down (print facing down).
NOTE:
To change default destination for copies, refer to Paper Output on page 8-14 for details.
Use the procedure below to select the output destination.
Ready to copy.
Paper Output
Place original.
Top Tray
Original : ---
Job Separator
Zoom : 100%
Tray
Paper : ---
Tray 4
Preview
Add Shortcut
Status
4-12
Top tray of the machine (where copies are stored)
Tray of the optional built-in finisher or document finisher
Trays A to C in the optional 3,000 sheet document finisher
Optional job separator
Trays 1 to 7 in the optional mailbox (tray 1 is the top tray)
Copies
Face Up
Face Down
Tray A Tray B Tray C
Tray 2 Tray 3
Tray 1
Tray 6 Tray 7
Tray 5
Cancel OK
08/08/2009
Description
1
Press the Copy key.
2
Place the originals on the platen.
3
Press [Org./Paper/Finishing] and then [Paper
Output].
4
Select the output destination for finished copies.
When you select [Finisher Tray], [Tray B], [Tray C]
or [Tray 1] to [Tray 7], select the orientation of
output copy, Face Up (print facing up) or Face
Down (print facing down).
5
Press [OK].
10:10
6
Press the Start key to start copying.
OPERATION GUIDE