Kyocera TASKalfa 420i Operation Manual page 297

Manual Setting (IPv6)
Manually specify the IP address, prefix length, and gateway address of TCP/IP (IPv6). The manual setting is
available when selecting [On] for TCP/IP (IPv6). Use the procedure below.
1
Press the System Menu key.
2
Press [System], [Next] of Network and then [Next] of TCP/IP Setting.
3
Press [Next] of IPv6.
4
Press [Next] of Manual Setting.
5
Press [IP Address (Manual)] to enter IP address. The format of the IPv6 address is a sequence of numbers
(128 bit in total) separated by colons, e.g. 2001:db8:3c4d:15::1a2c:1a1f.
6
Press [OK].
Press [# Keys] of Prefix Length (0 - 128) to enter the prefix length using the numeric keys.
7
Press [Default Gateway] to enter the default gateway.
8
Check that all the entries are correct and Press [OK].
9
After changing the setting, restart the system or turn the machine OFF and then ON again.
For detailed information on restarting the system, refer to Restarting the System on page 8-63.
RA (Stateless) Settings
Select whether or not to use RA (Stateless). The RA (Stateless) settings are available when selecting [On] for
TCP/IP (IPv6). The default setting is On. Use the procedure below.
1
Press the System Menu key.
2
Press [System], [Next] of Network and then [Next] of TCP/IP Setting.
3
Press [Next] of IPv6.
4
Press [Change] of RA(Stateless).
5
Press [On] or [Off] of RA (Stateless). When selecting [On], IP Address 1 to 5 (Stateless) appears.
6
Press [OK].
7
After changing the setting, restart the system or turn the machine OFF and then ON again.
For detailed information on restarting the system, refer to Restarting the System on page 8-63.
DHCP (IPv6) Settings
Select whether or not to use the DHCP (IPv6) server. The DHCP (IPv6) Settings are available when selecting
[On] for TCP/IP (IPv6). The default setting is On. Use the procedure below.
1
Press the System Menu key.
2
Press [System], [Next] of Network and then [Next] of TCP/IP Setting.
3
Press [Next] of IPv6.
OPERATION GUIDE
Default Setting (System Menu)
8
8-65