Auto Sleep; Auto Error Clear - Kyocera TASKalfa 420i Operation Manual

3
Press [+] or [–] to enter the time until Auto Panel Reset is turned on.
You cannot use the numeric keys to enter this value.
4
Press [OK].

Auto Sleep

If no job runs for a certain period of time, automatically enter Sleep Mode. Refer to Sleep and Auto Sleep on
page 2-9 for Sleep.
Sleep Timer
Set the amount of time to wait before Auto Sleep. Options are between 1 and 240 minutes (every one minute).
Use the procedure below to set the Auto Sleep time.
1
Press the System Menu key.
2
Press [ ], [Date/Timer] and then [Change] of Sleep Timer.
3
Press [+] and [–] or the numeric keys to enter the time until Auto Sleep is turned on.
4
Press [OK].

Auto Error Clear

If an error occurs during printing, the print job stops to wait for the next step to be taken by the user. In the Auto
Error Clear mode, automatically clear the error after a set amount of time elapses.
The following errors are automatically cleared.
Print overrun
Memory is full
Auto Error Clear ON/OFF
Select whether to use Auto Error Clear or not.
Use the procedure below to specify the auto error clear setting.
1
Press the System Menu key.
2
Press [ ], [Date/Timer] and then [Change] of Auto Error Clear.
3
Press [Off] or [On].
4
Press [OK].
Error Clear Timer
If you select [On] for Auto Error Clear, set the amount of time to wait before automatically clearing errors. Options
are between 5 and 495 seconds (every five seconds).
NOTE:
If you select [Off] for Auto Error Clear, the time display does not appear.
OPERATION GUIDE
Default Setting (System Menu)
8
8-49