Creating A Vsan; Configuring A Trunk Vsan; Displaying And Maintaining Vsans - HP FlexFabric 5700 Series Configuration Manual

list of the VFC interface. An FCoE frame transmitted from a VFC interface can use the VLAN ID in
VLAN_Header to identify the VLAN to which it belongs.

Creating a VSAN

By default, only the default VSAN (VSAN 1) exists. You cannot create or delete VSAN 1. You can create
VSANs 2 to 3839.
The maximum number of VSANs (including VSAN 1) allowed on a switch is 16.
To create a VSAN:
Step
1. Enter system view.
2. Create a VSAN and enter VSAN view.

Configuring a trunk VSAN

VFC interfaces can be assigned to multiple VSANs as trunk ports.
If you assign an interface to VSANs as a trunk port multiple times, the new configuration does not
overwrite the old configurations. The final trunk VSAN list is the union of all the VSANs to which you have
assigned the interface.
To assign an interface to the specified VSANs as trunk ports:
Step
Enter system view.
1.
2. Enter VFC interface view.
3. Assign the interface to the
specified VSANs as a trunk
port so that the interface
allows the specified VSANs
to pass through.

Displaying and maintaining VSANs

Execute display commands in any view.
Task
Display the member ports of VSANs.
Command
system-view
vsan vsan-id
Command
system-view
interface vfc interface-number
port trunk vsan vsan-id-list
Command
display vsan [ vsan-id ] port-member
27
Remarks
N/A
By default, only VSAN 1 exists.
Remarks
N/A
N/A
By default, an interface does not
belong to any VSANs (including
VSAN 1) as a trunk port.
You can assign an interface to a
nonexistent VSAN as a trunk port.