Configuring Support For Rfc-1483 Pvc - Cisco Catalyst 2900 XL Series Installation And Configuration Manual

Configuring Support for RFC-1483 PVC

Step 2
ATM1 is up, line protocol is up
ATM1.1 is up, line protocol is up
ATM#
Configuring Support for RFC-1483 PVC
You must manually configure the ATM module to support RFC-1483 logical link control
(LLC) encapsulation. By using RFC 1483, you can transport Ethernet frames over
permanent virtual connections (PVCs). You can create a PVC for RFC-1483 LLC
encapsulation support.
3-6
Catalyst 2900 Series XL ATM Modules Installation and Configuration Guide
Enter the show interface EXEC command:
ATM# show interface
Hardware is Catalyst 2900 ATM
Internet address is 199.90.198.195
MTU 1500 bytes, sub MTU 1500, BW 156250 Kbit, DLY 100 usec, rely
255/255, load
1/255
Encapsulation ATM, loopback not set, keepalive set (10 sec)
Encapsulation(s): AAL5, PVC mode
1024 maximum active VCs, 1024 VCs per VP, 22 current VCCs
VC idle disconnect time: 300 seconds
Signalling vc = 1, vpi = 0, vci = 5
UNI Version = 3.1, Link Side = user
Last input 00:00:07, output never, output hang never
Last clearing of "show interface" counters never
Queueing strategy: fifo
Output queue 0/40, 0 drops; input queue 0/75, 0 drops
5 minute input rate 3000 bits/sec, 3 packets/sec
5 minute output rate 2000 bits/sec, 3 packets/sec
82111 packets input, 10186865 bytes, 0 no buffer
Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
82152 packets output, 10176265 bytes, 0 underruns
0 output errors, 0 collisions, 3 interface resets
0 output buffer failures, 0 output buffers swapped out
Hardware is Catalyst 2900 ATM
MTU 1500 bytes, BW 156250 Kbit, DLY 100 usec, rely 255/255, load 1/255
Encapsulation ATM-LANE
ARP type: ARPA, ARP Timeout 04:00:00