Using The Cli To Configure Video Parameters - Cisco SD2008T-NA Configuration Manual

Chapter 4 Configuring Controller SettingsWireless Device Access
To enable or disable voice CAC for the 802.11a or 802.11b/g network, enter this command:
Step 4
config {802.11a | 802.11b} cac voice acm {enable | disable}
To set the percentage of maximum bandwidth allocated to clients for voice applications on the 802.11a
Step 5
or 802.11b/g network, enter this command:
config {802.11a | 802.11b} cac voice max-bandwidth bandwidth
The bandwidth range is 40 to 85%, and the default value is 75%. Once the client reaches the value
specified, the access point rejects new calls on this network.
To set the percentage of maximum allocated bandwidth reserved for roaming voice clients, enter this
Step 6
command:
config {802.11a | 802.11b} cac voice roam-bandwidth bandwidth
The bandwidth range is 0 to 25%, and the default value is 6%. The controller reserves this much
bandwidth from the maximum allocated bandwidth for roaming voice clients.
Step 7 To enable or disable TSM for the 802.11a or 802.11b/g network, enter this command:
config {802.11a | 802.11b} tsm {enable | disable}
Step 8 To enable the radio network, enter this command:
config {802.11a | 802.11b} enable network
To save your settings, enter this command:
Step 9
save config

Using the CLI to Configure Video Parameters

Follow these steps to configure video parameters using the CLI.
Step 1 Make sure that the WLAN is configured for WMM and the QoS level is set to Gold. See
Quality of Service" section on page 6-17
To disable the radio network, enter this command:
Step 2
config {802.11a | 802.11b} disable network
Step 3 To save your settings, enter this command:
save config
To enable or disable video CAC for the 802.11 or 802.11b/g network, enter this command:
Step 4
config {802.11a | 802.11b} cac video acm {enable | disable}
To set the percentage of maximum bandwidth allocated to clients for video applications on the 802.11a
Step 5
or 802.11b/g network, enter this command:
config {802.11a | 802.11b} cac video max-bandwidth bandwidth
The bandwidth range is 0 to 100%, and the default value is 0%. However, the maximum RF bandwidth
cannot exceed 100% for voice + video. Once the client reaches the value specified, the access point
rejects new calls on this network.
Ol-9141-03
for instructions.
Cisco Wireless LAN Controller Configuration Guide
Configuring Voice and Video Parameters
"Configuring
4-31