Cisco SD2008T-NA Configuration Manual page 379

Appendix D System Messages and LED Patterns
Table D-1
Error Message
LRADIF_NOISE_PROFILE_FAILED
LRADIF_INTERFERENCE_PROFILE_FAILED 802.11 interference has exceeded threshold on
LRADIF_COVERAGE_PROFILE_FAILED
LRADIF_LOAD_PROFILE_PASSED
LRADIF_NOISE_PROFILE_PASSED
LRADIF_INTERFERENCE_PROFILE_PASSED Detected interference is now less than threshold.
LRADIF_COVERAGE_PROFILE_PASSED
LRADIF_CURRENT_TXPOWER_CHANGED
LRADIF_CURRENT_CHANNEL_CHANGED
LRADIF_RTS_THRESHOLD_CHANGED
LRADIF_ED_THRESHOLD_CHANGED
LRADIF_FRAGMENTATION_THRESHOLD_
CHANGED
RRM_DOT11_A_GROUPING_DONE
RRM_DOT11_B_GROUPING_DONE
ROGUE_AP_DETECTED
ROGUE_AP_REMOVED
AP_MAX_ROGUE_COUNT_EXCEEDED
LINK_UP
LINK_DOWN
LINK_FAILURE
AUTHENTICATION_FAILURE
STP_NEWROOT
STP_TOPOLOGY_CHANGE
IPSEC_ESP_AUTH_FAILURE
IPSEC_ESP_REPLAY_FAILURE
IPSEC_ESP_POLICY_FAILURE
OL-9141-03
System Messages and Descriptions (continued)
Description
The non-802.11 noise has exceed configured
threshold.
channel -- check channel assignments.
Possible coverage hole detected - check Cisco
1000 Series lightweight access point history to see
if common problem - add Cisco 1000 Series
lightweight access points if necessary.
Load is now within threshold limits.
Detected noise is now less than threshold.
Number of clients receiving poor signal are within
threshold.
Informational message.
Informational message.
Informational message.
Informational message.
Informational message.
Informational message.
Informational message.
May be a security issue.Use maps and trends to
investigate.
Detected rogue access point has timed out. The
unit might have shut down or moved out of the
coverage area.
The current number of active rogue access points
has exceeded system threshold.
Positive confirmation message.
Port may have a problem or is administratively
disabled.
Port may have a problem or is administratively
disabled.
Attempted security breech. Investigate.
Informational message.
Informational message.
Check WLAN IPSec configuration.
Check for attempt to spoof IP Address.
Check for IPSec configuration mismatch between
WLAN and client.
Cisco Wireless LAN Controller Configuration Guide
System Messages
D-3