Cisco SD2008T-NA Configuration Manual page 149

Chapter 5 Configuring Security Solutions
To see the current MFP state for a particular WLAN, enter this command:
3.
show wlan wlan_id
Information similar to the following appears:
WLAN Identifier.................................. 1
Network Name (SSID).............................. tester-2006
Status........................................... Enabled
MAC Filtering.................................... Disabled
Broadcast SSID................................... Disabled
AAA Policy Override.............................. Disabled
Network Access Control........................... Disabled
Number of Active Clients......................... 0
Exclusionlist.................................... Disabled
Session Timeout.................................. 1800 seconds
Interface........................................ management
DHCP Server...................................... Default
Quality of Service............................... Silver (best effort)
WMM.............................................. Disabled
CCX - AironetIe Support.......................... Disabled
Dot11-Phone Mode (7920).......................... Disabled
Wired Protocol................................... None
IPv6 Support..................................... Disabled
Radio Policy..................................... All
Security
To see the current MFP state for a particular access point, enter this command:
4.
show ap config general AP_name
Information similar to the following appears:
Cisco AP Identifier.............................. 0
Cisco AP Name.................................... ap:52:c5:c0
AP Regulatory Domain............................. 80211bg: -N 80211a: -N
Switch Port Number .............................. 1
MAC Address...................................... 00:0b:85:52:c5:c0
IP Address Configuration......................... Static IP assigned
IP Address....................................... 10.67.73.33
IP NetMask....................................... 255.255.255.192
Cisco AP Location................................ default_location
Cisco AP Group Name.............................. default-group
Primary Cisco Switch............................. tester-2006
Secondary Cisco Switch...........................
Tertiary Cisco Switch............................
Administrative State ............................ ADMIN_ENABLED
Operation State ................................. REGISTERED
Mirroring Mode .................................. Disabled
AP Mode ......................................... Local
Remote AP Debug ................................. Disabled
S/W
Boot
Mini IOS Version ................................
OL-9141-03
802.11 Authentication:........................ Open System
Static WEP Keys............................... Disabled
802.1X........................................ Enabled
Encryption:................................... 104-bit WEP
Wi-Fi Protected Access (WPA1)................. Disabled
Wi-Fi Protected Access v2 (WPA2).............. Disabled
IP Security Passthru.......................... Disabled
Web Based Authentication...................... Disabled
Web-Passthrough............................... Disabled
Auto Anchor................................... Disabled
Management Frame Protection .................. Enabled
Version .................................... 4.0.2.0
Version ................................... 2.1.78.0
Configuring Management Frame Protection
--
Cisco Wireless LAN Controller Configuration Guide
5-19