Cisco SD2008T-NA Configuration Manual page 78

Configuring Ports
Table 3-5
Parameter
STP Port Path Cost
Click Apply to commit your changes.
Step 4
Click Save Configuration to save your changes.
Step 5
Click Back to return to the Ports page.
Step 6
Repeat
Step 7
Click Controller > Spanning Tree to access the Controller Spanning Tree Configuration page (see
Step 8
Figure
Figure 3-10
This page allows you to enable or disable the spanning tree algorithm for the controller, modify its
characteristics, and view the STP
Cisco Wireless LAN Controller Configuration Guide
3-26
Port Spanning Tree Parameters (continued)
Description
The speed at which traffic is passed through the port. This parameter
must be set if the STP Port Path Cost Mode parameter is set to User
Configured.
Options: 0 to 65535
Default: 0, which causes the cost to be adjusted for the speed of the
Note
Step 2 through Step 6 for each port for which you want to enable STP.
3-10).
Controller Spanning Tree Configuration Page
port when the link comes up.
Typically, a value of 100 is used for 10-Mbps ports and 19 for
100-Mbps ports.
status.Table 3-6 interprets the current STP status for the controller.
Chapter 3 Configuring Ports and Interfaces
OL-9141-03