Cisco SD2008T-NA Configuration Manual page 104

Changing the Default Values of SNMP Community Strings
Figure 4-1
Step 2 If "public" or "private" appears in the Community Name column, click Remove to delete this
community.
Click New to create a new community. The SNMP v1 / v2c Community > New page appears (see
Step 3
Figure
Figure 4-2
In the Community Name field, enter a unique name containing up to 16 alphanumeric characters. Do not
Step 4
enter "public" or "private."
In the next two fields, enter the IP address from which this device accepts SNMP packets with the
Step 5
associated community and the IP mask.
Choose Read Only or Read/Write from the Access Mode drop-down box to specify the access level for
Step 6
this community.
Step 7 Choose Enable or Disable from the Status drop-down box to specify the status of this community.
Click Apply to commit your changes.
Step 8
Click Save Configuration to save your settings.
Step 9
Repeat this procedure if a "public" or "private" community still appears on the SNMP v1 / v2c
Step 10
Community page.
Cisco Wireless LAN Controller Configuration Guide
4-10
SNMP v1 / v2c Community Page
4-2).
SNMP v1 / v2c Community > New Page
Chapter 4 Configuring Controller SettingsWireless Device Access
OL-9141-03