Using The Configuration Wizard; Before You Start; C H A P T E R 4 Configuring Controller Settingswireless Device Access - Cisco SD2008T-NA Configuration Manual

Using the Configuration Wizard

Using the Configuration Wizard
This section describes how to configure basic settings on a controller for the first time or after the
configuration has been reset to factory defaults. The contents of this chapter are similar to the
instructions in the quick start guide that shipped with your controller.
You use the configuration wizard to configure basic settings. You can run the wizard on the CLI or the
GUI. This section explains how to run the wizard on the CLI.
This section contains these sections:
•
•
•

Before You Start

You should collect these basic configuration parameters before configuring the controller:
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
Cisco Wireless LAN Controller Configuration Guide
4-2
Before You Start, page 4-2
Resetting the Device to Default Settings, page 4-3
Running the Configuration Wizard on the CLI, page 4-4
System name for the controller
802.11 protocols supported: 802.11a and/or 802.11b/g
Administrator usernames and passwords (optional)
Distribution system (network) port static IP address, netmask, and optional default gateway IP
address
Service port static IP address and netmask (optional)
Distribution system physical port (1000BASE-T, 1000BASE-SX, or 10/100BASE-T)
Each 1000BASE-SX connector provides a 100/1000-Mbps wired connection to a network
Note
through an 850nM (SX) fiber-optic link using an LC physical connector.
Distribution system port VALN assignment (optional)
Distribution system port web and secure web mode settings: enabled or disabled
Distribution system port Spanning Tree Protocol: enabled/disabled, 802.1D/fast/off mode per port,
path cost per port, priority per port, bridge priority, forward delay, hello time, maximum age
WLAN configuration: SSID, VLAN assignments, Layer 2 security settings, Layer 3 security
settings, QoS assignments
Mobility Settings: Mobility Group Name (optional)
RADIUS Settings
SNMP Settings
NTP server settings (the wizard prompts you for NTP server settings only when you run the wizard
on a wireless controller network module installed in a Cisco Integrated Services router)
Other port and parameter settings: service port, Radio Resource Management (RRM), third-party
access points, console port, 802.3x flow control, and system logging
Chapter 4 Configuring Controller SettingsWireless Device Access
OL-9141-03