Using The Gui To Configure Auto-Anchor Mobility - Cisco SD2008T-NA Configuration Manual

Chapter 11 Configuring Mobility GroupsWireless Device Access

Using the GUI to Configure Auto-Anchor Mobility

Follow these steps to create a new mobility anchor for a WLAN using the GUI.
See the
Note
to configure auto-anchor mobility using the CLI.
Click Controller > WLANs to access the WLANs page (see
Step 1
Figure 11-9 WLANs Page
On the WLANs page, click the Mobility Anchors link for the desired WLAN. The Mobility Anchors
Step 2
page for that WLAN appears (see
Figure 11-10 Mobility Anchors Page
Select the IP address of the controller to be designated a mobility anchor in the Switch IP Address
Step 3
(Anchor) drop-down box.
Click Mobility Anchor Create. The selected controller becomes an anchor for this WLAN.
Step 4
Note
OL-9141-03
"Using the CLI to Configure Auto-Anchor Mobility" section on page 11-14
To delete a mobility anchor for a WLAN, click Remove to the right of the controller's IP
address.
Figure 11-10).
Cisco Wireless LAN Controller Configuration Guide
Configuring Auto-Anchor Mobility
if you would prefer
Figure 11-9).
11-13